Matthew Blaire: Difference between revisions

Latest revision as of 01:09, 8 June 2011

Info:

 Email: matthew.blaire@wallawalla.edu
        b.there.dude@gmail.com
 Call Sign: KD0ORX

 Phone: 303-815-5651

@@ Line 3: / Line 3: @@
   '''Email:''' matthew.blaire@wallawalla.edu
          b.there.dude@gmail.com
+  '''Call Sign:''' KD0ORX
   '''Phone:''' 303-815-5651
+#[[LTspice Simulation|LTspice Simulation Data]]
-  '''LTspice Mixer Analysis:'''
-   What I basically did was I took the basic differential amplifier design and tested
-     the inputs with the two different designs: one with the data coming in through the
-     top transistor, and one where the data comes in through the bottom input. The pdf
-     diagramming the setups are displayed below.
-The following is a schematic with the data coming in the top Transistor.
-[[File:limit_on_top.gif|center|alt=A schematic]]
-The following is the simulation of the data.
-[[File:limit_on_top_graph.gif|center|alt=A graph]]
-You can see that some of the data is limited by the bottom resistor so this is not
-as good as the other way of which the simulation is done below.
-[[File:limit_on_bottom_circ.gif|center|alt=A schematic]]
-This is the Graph of the simulation, you can see that the data is passed in a better
-range and that the wave form of the slower wave data is taken from the faster data.
-[[File:limit_on_bottom.gif|center|alt=A graph]]
-There is still some distortion at the bottom of the graph but overall I think this passes better
-data than putting the oscillator on the top. If the transistors were biased
-better, I think that the data would show a little better.