Chapter 3

Diode load line

• Forward bias occurs when the P-type semiconductor material is connected to the positive terminal of a battery and the N-type semiconductor material is connected to the negative terminal, as shown below. This usually makes the p–n junction conduct. <ref> Wikipedia P-N junction</ref>

• Will the current always flow from the anode to the cathode when the diode is forward biased?

• Because diodes are a nonlinear device, traditional circuit analysis will not work on them. One method of analyze the diodes is to do it graphically. This technique is called Load-line analysis.

• Load-line is only used for dc analysis?

• In circuits with multiple diodes, it is not immediately apparent which diodes are on or off. The ideal-diode model assumes that the diode is a perfect conductor with zero voltage drop in the forward direction and an open circuit in the reverse direction.

• Is there a better, less exhaustive method to determine which diodes are on or off? With the current system, for n diodes there are $2^{n}$ possibilities.

1. Assume a set of states for the diodes
2. Solve the circuit to find $i_{D}$ for diodes assumed to be on and $v_{D}$ for diodes assumed to be off
3. Check to see if $i_{D}$ is positive for all diodes assumed to be on and if $v_{D}$ is negative for all diodes assumed to be off.

• Explain peak inverse voltage, PIV.
• Full-wave rectifier circuits: Center-tapped transformer & diode bridge. What are the pros and cons to each?
• Diode clipper circuits and their zener diode equivalents

Clamp Circuit

• The large capacitor acts as a DC offset and has a very small impedance for the AC signal
• Diodes are then used to define the upper and lower limit by conducting if the voltage goes outside their specified range.
• Why aren't the waveforms clipping in F3.20 (P149)

• Continue at 3.8

To Do

• Start up Chapter 3 problems
• Extend the bag of tricks post. Have subsections for op amps and diodes now. Then BJTs later.

References

<references/>